Hyundai Genesis (DH): 4 Wheel Drive (AWD) System
Hyundai Genesis (DH) 2013-2016 Service Manual / 4 Wheel Drive (AWD) System
- General Information
- Transfer Assembly
- Transfer Case Assembly Components and Components Location
- Transfer Case Assembly Repair procedures
- Transfer Fluid Specifications
- Transfer Fluid Repair procedures
- Front Axle Flange Repair procedures
- Rear Axle Flange Repair procedures
- O-Ring Radial Repair procedures
- Seal Ring Radial Repair procedures
- AWD Control System
Removal 1. Remove the nut (B) and clip (C). 2. Remove the shift cable (A) assembly from the transmission. Tightening torque : 12.7 ~ 15.7 N.
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.
Hyundai Genesis (DH) 2013-2016 Service Manual: Console Temperature Control Actuator Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the console temperature control actuator connector. 3. Verify that the console temperature control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Engine Electrical System
- Components and Components Location
- Body (Interior and Exterior)
- New on site
- Most important about car
Copyright В© 2026 www.hgenesisdh.com - 0.0247