Hyundai Genesis (DH): Body Electrical System / Indicators And Gauges
- Instrument Cluster Components and Components Location
- Instrument Cluster Schematic Diagrams
- Instrument Cluster Description and Operation
- Instrument Cluster Repair procedures
- Troubleshooting
Fuse Inspection 1. Check that the fuse holders are loosely held and that the fuses are securely fixed by the holders. 2. Check that each fuse circuit has the exact fuse capacity.
Components Connector Pin Information No.DescriptionNo.Description1-21-2Illumination output22-3Rheostat down switch234P output4Rheostat up switch24Immobilizer5AT N output25AT S output6Oil pressure26AT R output7Low washer27AT P output8Charge28-9AT D output29-10Illumination +30MM_CAN High11-31MM_CAN Low12Active ECO32C_CAN High13Heated wheel indicator33C_CAN Low14Fuel34Trip switch115Detent output35Trip switch216Fuel ground36Trip switch ground17-37Signal ground18Speaker -38-19Speaker +39IGN +20Aig bag +40Battery +
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Hyundai Genesis (DH) 2013-2016 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative (-) battery terminal. 3. Remove the engine room cover.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Rain Sensor Repair procedures
- Smart Cruise Control Unit Repair procedures
- Heating, Ventilation and Air Conditioning
- New on site
- Most important about car
