Hyundai Genesis: RCTA (Rear Cross Traffic Alert) / Warning type
If the vehicle detected by the sensors
approaches your vehicle, the warning
chime will sound, the warning
light on the outside rearview mirror
will blink and a message will appear
on the LCD display.
✽ NOTICE
- If the detected vehicle is out of the
sensing range of your vehicle,
move the vehicle away from the
detected object slowly; the warning
will be cancelled.
- The system may not operate properly
due to other factors or circumstances.
Always pay attention
to your surrounding.
- If your vehicle's left or right side
bumper is blinded by barrier or
vehicles, the system sensing ability
may be reduced.
WARNING
- The warning light on the outside
rearview mirror will illuminate
whenever a vehicle is
detected at the rear side by
the system.
To avoid accidents, do not
focus only on the warning
light and neglect to see the
surrounding of the vehicle.
- Drive safely even though the
vehicle is equipped with a
Blind Spot Detection System
(BSD) and Rear Cross Traffic
Alert (RCTA). Do not solely
rely on the system but check
your surrounding before
changing lanes or backing the
vehicle up.
The system may not alert the
driver in some conditions so
always check the surroundings
while driving.
- The Blind Spot Detection
System (BSD) and Rear Cross
Traffic Alert (RCTA) are not a
substitute for proper and safe
driving practices. Always
drive safely and use caution
when changing lanes or backing
the vehicles up. The Blind
Spot Detection System (BSD)
may not detect every object
alongside the vehicle.
CAUTION
- The system may not work
properly if the bumper has
been replaced or if repair work
has been done near the sensor.
- The detection area differs
according to the roads width. If
the road is narrow the system
may detect other vehicles in
the next lane. In addition, if the
road is very wide the system
may not detect other vehicles.
- The system may turn off due to
strong electromagnetic waves.
Operating conditions
To operate:
Go to the User Settings Mode
(Driving Assist) and select RCTA
(Rear Cross Traffic Alert) on the LCD
display (For more details, refer to
"LCD Display" in ch ...
Outside rearview mirror may not
alert the driver when:
- The outside rearview mirror housing
is damaged or covered with
debris.
- The window is covered with debris.
- The windows are severe ...
Other information:
Inspection
Connect the motor to battery and check the motor for proper
operation. Then reverse the battery terminals to be connected and check
that the motor operates properly in the reverse direction. If the
operation is abnormal, replace the motor.Removal
1.
Disconnect the negative (- ...
Removal
Crash pad lower panel switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the crash pad lower panel switch (A) after disengaging the mounting clip.
Wear gloves to ...