Hyundai Genesis: Blind Spot Detection System (BSD) / RCTA (Rear Cross Traffic Alert)

Operating conditions

To operate:

Go to the User Settings Mode (Driving Assist) and select RCTA (Rear Cross Traffic Alert) on the LCD display (For more details, refer to "LCD Display" in chapter 3.). The system will turn on and standby to activate. The system will activate when vehicle speed is below 6 mph (10 km/h) with the shift lever in R (Reverse).

✽ NOTICE

The RCTA (Rear Cross Traffic Alert) detecting range is about 1 feet (0.5 m) ~ 65 feet (20 m). A vehicle will be detected if the vehicle speed is 2.5 mph (4 km/h) ~ 22 mph (36 km/h) within the detecting range. However, the detecting range may change under different conditions. Always pay attention to the surroundings.

BSD (Blind Spot Detection) / LCA (Lane Change Assist)
Operating conditions To operate: Press the BSD switch with the Engine Start/Stop button in the ON position. The indicator illuminates on the switch. If vehicle speed exceeds 20 mph (30km/h ...

Warning type
If the vehicle detected by the sensors approaches your vehicle, the warning chime will sound, the warning light on the outside rearview mirror will blink and a message will appear on the L ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Surge Tank Repair procedures


Removal and Installation 1. Disconnect the battery "-" terminal from the trunk room. 2. Remove the engine cover. 3. Remove the engine room cover. (Refer to Engine And Transaxle Assembly - "Engine Cover") 4. Remove the Cowl Top Cover. (Refer to Body - "Cowl Top Cover") 5. Remove ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Rail Pressure Sensor (RPS) Repair procedures


Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ConditionOutput Voltage (V)Idle Approx. 1.21,500 rpm2.0 ~ 2.26,300 rpm Approx. 2.8 Removal 1. Turn the ignition switch OFF and dis ...

© 2013-2025 www.hgenesisdh.com