Hyundai Genesis: Trunk Lid / Trunk Lid Trim Components and Components Location

Hyundai Genesis (DH) 2013-2016 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Trim Components and Components Location

Component Location

1. Trunk lid trim


Trunk Lid Assembly Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing and installing the trunk lid, an assistant is necessary . â ...

Trunk Lid Trim Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: PGS Unit (Back & Blinde Unit) Repair procedures


Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing. 3. Connector the negati ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Knock Sensor (KS) Repair procedures


Removal [Knock Sensor #1 (Bank 1)] 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the knock sensor connector (A). 3. Remove the installation bolt (A), and then remove the sensor from the cylinder block. [Knock Sensor #2 (Bank 2)] 1 ...

© 2013-2025 www.hgenesisdh.com