Hyundai Genesis: AUTO HOLD / To apply

1. Press the [AUTO HOLD] switch. The AUTO HOLD indicator will illuminate white and the system will be in the standby position.

2. When you stop the vehicle completely by depressing the brake pedal, the Auto Hold maintains the brake pressure to hold the vehicle stationary. The indicator changes from white to green.

3. The vehicle will remain stationary even if you release the brake pedal.

4. If EPB is applied, Auto Hold will be released.

AUTO HOLD

This feature keeps the brake applied when the shift lever is in D (Drive), R (Reverse), N (Neutral) or Sports Mode with the feature enabled and when the brake pedal has been depressed to sto ...

To release

Press the accelerator pedal with the shift lever in R (Reverse), D (Drive) or Sports Mode, the Auto Hold will be released automatically and the vehicle will start to move. The indica ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Hood Seal Weatherstrip Repair procedures

Replacement 1. Remove the hood seal weatherstrip (A) and then remove the clip from the panel.     • Be careful not to scratch the hood seal weatherstrip. 2. Install in the reverse order of removal.     • Replace any damaged clips. • ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Engine Room Under Cover Components and Components Location

Components [2WD] 1. Front under cover2. Rear under cover3. LH side cover4. RH side cover [AWD] 1. Front under cover2. Rear under cover3. LH side cover4. RH side cover ...