Hyundai Genesis: Roof Trim / Sunvisor Repair procedures

Replacement
   
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
Take care not to bend or scratch the trim and panels.
1.
Loosen the mounting screws, and then remove the sunvisor (A) and retainer (B).

2.
Disconnect the sunvisor lamp connector (A).

3.
Install in the reverse order of removal.
   
Make sure the connector is connected properly.
Sunvisor Components and Components Location
Component Location 1. Sunvisor2. Retainer ...

Assist Handle Components and Components Location
Component Location 1. Assist handle ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location


Component Location 1. BCM (Body Control Module)2. Ultrasonic sensor     Rear parking assist control unit function is built in BCM (body control unit). ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Surge Tank Repair procedures


Removal and Installation 1. Disconnect the battery "-" terminal from the trunk room. 2. Remove the engine cover. 3. Remove the engine room cover. (Refer to Engine And Transaxle Assembly - "Engine Cover") 4. Remove the Cowl Top Cover. (Refer to Body - "Cowl Top Cover") 5. Remove ...

© 2013-2025 www.hgenesisdh.com