Hyundai Genesis (DH): BCM (Body Control Module) / Specifications
| Specifications |
| Items | Specifications |
| Rated voltage | DC 12V |
| Operating voltage | DC 9 ~ 16V |
| Operating temperature | -30 |
Components NOConnector AConnector BConnector C1Battery +-Room lamp Output2IGN1ECM Mirror +Foot lamp Output3IGN2B CAN High-4ACCB CAN Low-5-PAS (LIN)-6-Integrated sensor (LIN)L_Head lamp washer RLY_OUT7Rear Window Defroster switch-External buzzer output8parking brake switch-SSB light output9PAS off switch-Mood lamp output10Rear curtain switch-Rear curtain motor down Output11sunroof state-Rear curtain motor UP Output12--ATM Solenoid outputs13Trunk open switch-Rear Seat belt light output(RH)14L_NADRI_OPT_INRear Seat belt light output(LH)Rear defogger light output 15L_Deolicated DRI_OPT_INRear Seat belt light output(Center)PAS on light output 16-GND (Power)safety belt light output (Assist)17-? security light output 18-?-19-?-20-?-21-?GND (Rear curtain motor)22-?Rear curtain Power23-??24-??25-??26GND??
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: In-car Sensor Repair procedures
I
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Automatic Transmission Control System
- TPMS Receiver Description and Operation
- Parking Assist Sensor Repair procedures
- New on site
- Most important about car
