Other information:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the injector terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
...
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with the L wrench (A).
Tightening torque :
9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
3.
Remove the receiver-drier (A) from condenser using a long
nose plier. Check for crumbled ...