Seat warmers
Seat warmers are provided to warm
the seats during cold weather.
WARNING
The seat warmers can cause a
serious burn, even at low temperatures
and especially if used
for long periods of time.
Passengers must be able to feel
if the seat is becoming too warm
so they can turn it off, if needed.
People who cannot detect temperature
change or pain to the
skin should use extreme caution,
especially the following
types of passengers:
- Infants, children, elderly or
disabled persons, or hospital
outpatients.
- People with sensitive skin or
who burn easily.
- Fatigued individuals.
- Intoxicated individuals.
- People taking medication that
can cause drowsiness or
sleepiness.
WARNING
NEVER place anything on the
seat that insulates against heat
when the seat warmer is in operation,
such as a blanket or seat
cushion. This may cause the
seat warmer to overheat, causing
a burn or damage to the seat.
CAUTION
To prevent damage to the seat
warmers and seats:
- Never use a solvent such as
paint thinner, benzene, alcohol
or gasoline to clean the
seats.
- Do not place heavy or sharp
objects on seats equipped
with seat warmers.
- Do not change the seat cover.
It may damage the seat
warmer or air ventilation system.


While the engine is running, push the
switch to warm the seat.
During mild weather or under conditions
where the operation of the seat
warmer is not needed, keep the
switches in the OFF position.
- Each time you push the switch, the
temperature setting of the seat is
changed as follows :

- When pressing the switch for more
than 1.5 seconds with the seat
warmer operating, the seat warmer
will turn OFF.
- The seat warmer defaults to the
OFF position whenever the Engine
Start/Stop button is in the ON position.
✽ NOTICE
With the seat warmer switch in the
ON position, the heating system in
the seat automatically controls the
seat temperature by designed temperature.
Other information:
Description
The photo sensor is located in the right side of the inside rearview mirror.
he integrated rain sensor is located in the right side of the
inside rearview mirror. The integrated rain sensor is a multifunctional
sensor which combines the photo sensor and auto light sensor, and ha ...
Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the drive belt auto tensioner (A).
Tightening torque
Bolt (B) :
81.4 ~ 85.3 N.m (8.3 ~ 8.7 kgf.m, 60.0 ~ 62.9 lb-ft)
Bolt (C) :
17.7 ~ 21.6 N.m (1.8 ~ 2.2 kgf.m, 13.0 ~ 15.9 b-ft)
...