Hyundai Genesis: Recommended lubricants and capacities / Recommended SAE viscosity number

CAUTION

Always be sure to clean the area around any filler plug, drain plug, or dipstick before checking or draining any lubricant. This is especially important in dusty or sandy areas and when the vehicle is used on unpaved roads. Cleaning the plug and dipstick areas will prevent dirt and grit from entering the engine and other mechanisms that could be damaged.

Engine oil viscosity (thickness) has an effect on fuel economy and cold weather operating (engine start and engine oil flowability). Lower viscosity engine oils can provide better fuel economy and cold weather performance, however, higher viscosity engine oils are required for satisfactory lubrication in hot weather. Using oils of any viscosity other than those recommended could result in engine damage.

When choosing an oil, consider the range of temperature your vehicle will be operated in before the next oil change. Proceed to select the recommended oil viscosity from the chart.

Recommended lubricants and capacities

To help achieve proper engine and powertrain performance and durability, use only lubricants of the proper quality. The correct lubricants also help promote engine efficiency that results in imp ...

Vehicle identification number (VIN)

The vehicle identification number (VIN) is the number used in registering your car and in all legal matters pertaining to its ownership, etc. The number is punched on the floor under the pa ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

Components Location 1. Fuel tank2. Fuel pump3. Sub fuel sender4. Fuel filter5. Over Pressure Valve (OPV)6. Canister7. Fuel tank air filter8. Fuel Pressure Sensor (FPS)9. Fuel Tank Pressure Sensor (FTPS)10. Canister Close Valve (CCV)11. Fuel Level Sensor (FLS)12. Fuel Filler hose13. Leveli ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Spark Plug Specifications

Specification ItemSpecificationTypeDILKR7A11Gap 1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.) ...