Hyundai Genesis: Rear Curtain System / Rear Curtain Switch Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel")

3.	Remove the crash pad lower panel switch (A) after disengaging the mounting clip. Wear gloves to protect hands from injury.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the drink holder pad (A).

3.	Loosening the mounting screws (A).

4.	Using a screwdriver or remover, remove the rear seat armrest drink holder assembly (A).

5.	Disconnect the connector (B).

6.	Remove the curtain switch (A) after loosening the mounting screws.

Installation

1.	Install the side crash pad switch assembly.

2.	Install the crash pad lower panel.

3.	Connect the negative (-) battery terminal.

1.	Install the rear curtain switch.

2.	Install the rear seat armrest in the armrest.

Inspection

Initial condition	Inspection list	Normal value
1) IGN ON (DC 12V)	1) Rear curtain UP state  - Rear curtain switch input(ON)	Rear curtain DOWN
	2) Rear curtain DOWN state  - Rear curtain switch input(ON)	Rear curtain UP
	3) Rear curtain AUTO UP/DOWN activating  - Rear curtain switch input(ON)	Reversal movement

Initial condition	Inspection list	Normal value
1) IGN ON(DC 12V) 2) Rear curtain UP	1) Transmission lever(P,D,N)->R	Rear curtain DOWN
	2) Rear curtain DOWN by No.1)  - Below 20 Km/h in the transmission lever D,N	Rear curtain DOWN
	3) Rear curtain DOWN by No.1) - Over 20 Km/h in the transmission lever D,N	Rear curtain UP
	4) Rear curtain DOWN by No.1)  - Transmission lever P	Rear curtain UP

If a driver operates the rear curtain down by a rear curtain switch, the rear curtain doesn't do AUTO return.

Rear Curtain Switch Components and Components Location

Components ...

Electro Chromic Inside Rear View Mirror

...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp check. The lamp shall turn on for 6 seconds during the initialization phase and turn off afterward. ...

Hyundai Genesis (DH) 2013-2016 Service Manual: General Information

General Troubleshooting Information Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Check the battery for damage, state of charge, and cleanness and tight connections. (Refer to Engine Electrical System - "Battery")     • Do no ...