Hyundai Genesis: Driver assist system / Parking Assist System

The Parking Assist System assists the driver during movement of the vehicle by chiming if any object is sensed within the distance of 39 inches (100 cm ) in front and 47 inches (120 cm) behind the vehicle.

This system is a supplemental system that senses objects within the range and location of the sensors, it cannot detect objects in other areas where sensors are not installed.

WARNING

• ALWAYS look around your vehicle to make sure there are not any objects or obstacles before moving the vehicle in any direction to prevent a collision.
• Always pay close attention when the vehicle is driven close to objects, particularly pedestrians, and especially children.
• Be aware that some objects may not be visible on the screen or be detected by the sensors, due to the objects distance, size or material, all of which can limit the effectiveness of the sensor.

Parking Guide System

The Parking Guide System (PGS) will activate when the back-up light is ON with the Engine Start/Stop button ON and the shift lever in the R (Reverse) position. The Parking Guide System is ...

Operation of the Parking Assist System

Operating condition - When the Engine Start/Stop button is in the ON position - When the shift lever is in D or R position - When the vehicle speed is not over 6 mph (10 km/h) Push the p ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Door Mood Lamp Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front Door Trim") 3. Disconnect the door mood lamp connectors (A). 4. Remove the door mood lamp (A) after loosening the screws (3EA). 5. If it is necessary to replace the b ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Overhead Console Lamp Repair procedures

Inspection 1. Remove the overhead console lamp assembly and check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the mounting screws (2EA). And then remove the ...