Hyundai Genesis: Timing System / Idler Repair procedures

Removal and Installation

1.	Remove the drive belt. (Refer to Timing System - "Drive Belt")

2.	Remove the drive belt idler (A). Tightening torque : 44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

3.	To install, reverse the removal procedure.

Inspection

1.	Check the idler for excessive oil leakage, abnormal rotation or vibration. Replace if necessary.

2.	Check the belt tensioner for excessive dust, crack, and damage. Replace if necessary.

3.	Check belt for maintenance and abnormal wear of V-ribbed part. Replace if necessary.

4.	Check the pulleys for vibration in rotation, oil or dust deposit of V-ribbed part. Replace if necessary.

Idler Components and Components Location

Components 1. Idler ...

Drive Belt Tensioner Components and Components Location

Components 1. Drive belt tensioner ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Crash pad side garnish assembly Repair procedures

Replacement     • Be careful not to scratch or dent the crash pad garnish and door trim upper garnish because these parts are made of weak material (real wood). • Put on gloves to prevent hand injuries.     • When removing with a flat ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Parking Assist Sensor Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (B) from the parking assist sensor (A). 4. Remove the sensor (A) by pulling out b ...