Hyundai Genesis: Smart High Beam / Headlamp delay function
If you place the Engine Start/Stop button in to the ACC or OFF position with the headlamps ON, the headlamps (and/or parking lamps) remain on for about 5 minutes. However, with the engine off if the driver’s door is opened and closed, the headlamps (and/or parking lamps) are turned off after 15 seconds.
The headlamps (and/or parking lamps) can be turned off by pressing the lock button on the smart key twice or turning the light switch to the OFF or AUTO position. However, if you turn the light switch to the AUTO position when it is dark outside, the headlamps will not be turned off.
You can activate or deactivate the Headlamp Delay function from the User Settings Mode (Light) on the LCD display.
✽ NOTICE
If the driver gets out of the vehicle through other doors (except driver's door), the battery saver function does not operate and the headlamp delay function does not turn off automatically. Therefore, It causes the battery to be discharged. In this case, make sure to turn off the lamp before getting out of the vehicle.
Battery saver function
The purpose of this feature is to prevent
the battery from being discharged.
The system automatically
turns off the parking lamp when the
driver turns the engine off and opens
the driver-sid ...
Daytime running light (DRL)
The Daytime Running Lights (DRL)
can make it easier for others to see
the front of your vehicle during the
day, especially after dawn and before
sunset.
for U.S.A
The DRL will turn off when: ...
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Barometric Pressure Sensor (BPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the BPS at idle and with the ignition ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disco ...
Hyundai Genesis (DH) 2013-2016 Service Manual: Overhead Console Lamp Repair procedures
Inspection 1. Remove the overhead console lamp assembly and check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the mounting screws (2EA). And then remove the ...
