Hyundai Genesis (DH): Fuel Delivery System / Filler-Neck Assembly Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal

1.	Remove the filler neck mounting screws (A) after opening the fuel filler door.

2.	Remove the rear-left wheel & tire and wheel house cover.

3.	Disconnect the fuel filler hose (A) and leveling hose (B).

4.	Disconnect the vent hose quick-connector (C).

5.	Remove the filler-neck assembly (B) from the vehicle after removing bracket mounting nuts (A).

Installation

To install, reverse the removal procedure.

Filler-neck assembly installation nut :

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lbf.ft)

❮Fuel Line Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 3.

Accelerator Pedal Repair procedures❯

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A).

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: A/C Pressure Transducer Description and Operation

Description The A/C Pressure Transducer (APT) converts the pressure value of high-pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it at high speed or low speed.

Hyundai Genesis (DH): Fuel Delivery System / Filler-Neck Assembly Repair procedures

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: A/C Pressure Transducer Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual: In-car Sensor Repair procedures

Categories