Hyundai Genesis: What to do in an emergency / Hazard warning flasher

The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle.

It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.

To turn the hazard warning flasher on or off, press the hazard warning flasher button with the Engine Start/Stop button in any position. The button is located in the center fascia panel. All turn signal lights will flash simultaneously.

• The hazard warning flasher operates whether your vehicle is running or not.
• The turn signals do not work when the hazard flasher is on.

What to do in an emergency

...

In case of an emergency while driving

If the engine stalls while driving Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. Turn on your hazard warning flasher. Try to start t ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: SRS Control Module (SRSCM) Repair procedures

Removal 1. Turn the engine OFF. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console assembly. (Refer to Body - "Floor Console Assembly") 4. Pull up the lock of the SRSCM connector to disconnect the connector ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Heater & A/C Control Unit Repair procedures

Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup temperature display panel every 0.5 second and will show two figures. Codes are displayed in numer ...