| Circuit Diagram |


Components 1. Hands free call switch2. Overhead console (Mic)3. Front left speaker4. Front right speaker5. Audio head unit (hands free control) ? There is no hands free jack.
Inspection 1. Check for resistance between terminals in each switch position(LH). [Audio] SwitchConnectorterminalResistance(
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to Body - "Glove Box") 3. Remove the PGS unit (A) after loosening the nuts. Installation 1. Install the PGS unit. 2. Install the glove box housing.
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with the L wrench (A). Tightening torque : 9.81 ~ 14.71 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier.