Hyundai Genesis (DH): Front Door / Front Door Side Weatherstrip Repair procedures

Replacement
1.
Loosen the front door checker (B) mounting bolt.
2.
Detach the clips, then remove the front door side weatherstrip (A).

Tightening torque :
16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft)

3.
Install in the reverse order of removal.
   

    Replacement 1. Pull down the front door window glass to the lowest level by pressing the power window glass switch. 2. After loosening the mounting screws, remove the front door belt outside weatherstrip (A).

    Replacement 1. Remove the front door module. (Refer to Front Door - "Front Door Module") 2. To remove the front door outside handle base connector (A), widen both sides of the wiring fastener (A) and then push back the front door outside handle base connector.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Head Lamp Leveling Unit Troubleshooting

    Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. The following is the summarized A/S procedure. NoProcedure1Park the vehicle on level ground2Tire check3IGN1 ON4Head lamp Low Beam ON5Connection with diagnostic tool6Initial command by diagnostic tool7Clear DTC Code8IGN1 OFF > ON9Re- Connection with diagnostic t

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Sensor Description and Operation

    Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator,

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0301