Hyundai Genesis: Automatic climate control system / Climate control air filter

The climate control air filter installed behind the glove box filters the dust or other pollutants that come into the vehicle from the outside through the heating and air conditioning system. If dust or other pollutants accumulate in the filter over a period of time, the air flow from the air vents may decrease, resulting in moisture accumulation on the inside of the windshield even when the outside (fresh) air position is selected. If this happens, have the climate control air filter replaced by an authorized HYUNDAI dealer.

✽ NOTICE

  • Replace the filter according to the maintenance schedule. If the car is being driven in severe conditions such as dusty or rough roads, more frequent air conditioner filter inspections and changes are required.
  • When the air flow rate suddenly decreases, the system should be checked at an authorized HYUNDAI dealer.
Air conditioning
1. Start the engine. Push the air conditioning button. 2. Set the mode to the position. 3. Set the air intake control to the outside air or recirculated air position. 4. Adjust the fan speed c ...

Checking the amount of air conditioner refrigerant and compressor lubricant
When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a negative impact on the air conditioning system. Therefore, if abnormal operat ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location


Components Location 1. PCV Valve2. Canister3. Purge Control Solenoid Valve (PCSV)4. Fuel Tank Pressure Sensor (FTPS)5. Canister Close Valve (CCV)6. Fuel Level Sensor (FLS)7. Fuel Tank Air Filter8. Catalytic Converter (WCC, Bank 1)9. Catalytic Converter (WCC, Bank 2)10. Catalytic Converter (U ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Barometric Pressure Sensor (BPS) Repair procedures


Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the BPS at idle and with the ignition ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disco ...

© 2013-2025 www.hgenesisdh.com