Hyundai Genesis (DH): Intake And Exhaust System / Variable Intake Solenoid(VIS) Actuator Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Engine Mechanical System / Intake And Exhaust System / Variable Intake Solenoid(VIS) Actuator Repair procedures

Removal and Installation
1.
Disconnect the battery "-" terminal from the trunk room.
2.
Remove the engine cover.
(Refer to Engine And Transaxle Assembly - "Engine Cover")
3.
Remove the VIS actuator (A).

Tightening torque :
3.9~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 Ib-ft)

4.
To install, reverse the removal procedure.

    Removal and Installation [Air Cleaner Assembly] 1. Disconnect the battery "-" terminal from the trunk room. 2. Remove the engine cover. (Refer to Engine And Transaxle Assembly - "Engine Cover") 3.

    Components 1. Surge tank2. VIS actuator

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Head Lamp Leveling Unit Repair procedures

    Inspection 1. Ignition "ON". 2. Turn on the head lamp switch. 3. Check that the aim of the head lamp changes smoothly when the head lamp leveling device switch is turned on. 4. If it does not operate well, check the connector and terminals to make sure that they are connected.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Description and Operation

    Description The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0297