Hyundai Genesis: Anti-lock Brake System (ABS) / Using ABS
To obtain the maximum benefit from your ABS in an emergency situation, do not attempt to modulate your brake pressure and do not try to pump your brakes. Depress your brake pedal as hard as possible.
When you apply your brakes under conditions which may lock the wheels, you may hear sounds from the brakes, or feel a corresponding sensation in the brake pedal. This is normal and it means your ABS is active.
ABS does not reduce the time or distance it takes to stop the vehicle.
Always maintain a safe distance from the vehicle in front of you.
ABS will not prevent a skid that results from sudden changes in direction, such as trying to take a corner too fast or making a sudden lane change. Always drive at a safe speed for the road and weather conditions.
ABS cannot prevent a loss of stability. Always steer moderately when braking hard. Severe or sharp steering wheel movement can still cause your vehicle to veer into oncoming traffic or off the road.
On loose or uneven road surfaces, operation of the anti-lock brake system may result in a longer stopping distance than for vehicles equipped with a conventional brake system.
The ABS warning light (.gif)
) will
stay
on for several seconds after the
Engine Start/Stop button is in the ON
position. During that time, the ABS
will go through self-diagnosis and the
light will go off if everything is normal.
If the light stays on, you may
have a problem with your ABS.
Contact an authorized HYUNDAI
dealer as soon as possible
WARNING
If the ABS warning light () is
on and stays on, you may have
a problem with the ABS. Your
power brakes will work normally.
To reduce the risk of serious
injury or death, contact your
HYUNDAI dealer as soon as
possible.
CAUTION
When you drive on a road having
poor traction, such as an icy
road, and apply your brakes
continuously, the ABS will be
active continuously and the
ABS warning light () may
illuminate. Pull your car over to
a safe place and turn the engine
off.
Restart the engine. If the ABS warning light is off, then your ABS system is normal.
Otherwise, you may have a problem with your ABS system. Contact an authorized HYUNDAI dealer as soon as possible.
✽ NOTICE
When you jump start your vehicle
because of a drained battery, the
ABS warning light () may turn
on at the same time. This happens
because of the low battery voltage. It
does not mean your ABS is malfunctioning.
Have the battery recharged
before driving the vehicle.
Anti-lock Brake System (ABS)
WARNING
An Anti-Lock Braking System
(ABS) or an Electronic Stability
Control (ESC) system will not
prevent accidents due to
improper or dangerous driving
maneuvers. Even though vehicle
co ...
Electronic Stability Control
(ESC)
The Electronic Stability Control
(ESC) system helps to stabilize the
vehicle during cornering maneuvers.
ESC checks where you are steering
and where the vehicle is actually
going. ESC appl ...
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Front Door Window Glass Repair procedures
Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. After loosening the mounting screws, remove the front door belt outside weatherstrip (A). 3. Separating the mounting plug hole (A) from the front door module. Lower the glass by operating the power ...
Hyundai Genesis (DH) 2013-2016 Service Manual: Parking Brake Assembly Repair procedures
Removal Parking Brake Pedal 1. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 2. Remove the IPM after removing the nut and connector. (Refer to Body Electrical System - "BCM") 3. Disconnect the parking brake switch connector (A). 4. Remove the parking brake pedal ...
