Hyundai Genesis (DH): Automatic Transmission Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between solenoid valve terminals.
4.
Check that the resistance is within the specification.

    Circuit Diagram

    Description 8LR Brake control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 8LR Brake.

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Start/Stop Button Repair procedures

    Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the start/stop button (A) from the center fascia garnish after loosening the mounting clip.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blower Unit Components and Components Location

    Component Location Components 1. Seal2. Intake Duct Case3. Intake Door4. Intake Actuator5. Intake Duct Case (A)6. Climate Control Air Filter7. Climate Control Air Filter Cover8. Cluster Ionizer9. Blower Upper Case10. Blower Lower Case11. Power Mosfet12.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0292