Hyundai Genesis (DH): SRSCM / Seat Belt Buckle Switch (BS) Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Description and Operation

Description
The SRSCM monitors the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status modify the SRSCM deployment. If the buckle status is unbuckled, the corresponding pretensioner will not be deactivated.

    Removal    

    Components

    Other information:

    Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Hyundai Genesis (DH) 2013-2016 Service Manual: Components and Components Location

    Component Location Index Engine Room [Lambda Engine] 1. Expansion Valve2. Suction & Liquid Tube Assembly3. Service Port (Low Pressure)4. Service Port (High Pressure)5. A/C Pressure Transducer (APT)6. Compressor7. Condenser8. Receiver-drier [Tau Engine] 1.

    Categories

     
    Copyright В© 2026 www.hgenesisdh.com - 0.0275