Hyundai Genesis: Front Door / Repair procedures

Adjustment

• Check the glass run channel for damage or deterioration, and replace it if necessary.

1.	Remove the front door trim. (Refer to Front Door - "Front Door Trim")

2.	Separate the mounting plug hole (A) from the front door module.

3.	After loosening the glass mounting bolts, adjust the spacing of the glass (B) by moving the glass from side to side and then tighten the bolts.

4.	Check the glass for normal operation.

1.	Remove the front striker cover (A).

2.	After loosening the mounting screw, adjust the striker (A) by moving it forward and backward or from side to side and then tighten the bolts (B). Tightening torque : (B) : 16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft)

3.	Tap on the striker with a plastic hammer to adjust the striker. The striker will not move much, but will give some adjustment.

4.	Hold the outer handle out, and push the door against the body to be sure the striker allows a flush fit. If the door latches properly, tighten the screws and recheck.

• After installing the door, check that the body fits flush with/parallel to all the edges of front door. Check that the door and body edges are parallel. Before adjusting, replace the mounting bolts.

1.	Check that the door and body edges are parallel.

2.	Place the vehicle on a level surface before adjusting the doors.

3.

Adjust the hinges (A) : A. Loosen the door mounting bolts slightly, and move the door in or out until it fits flush with the body. B. Loosen the hinge mounting bolts slightly, and move the door backward or forward, up or down as necessary to make the gaps equal. C. Place a shop towel on the jack to prevent damage to the door when adjusting the door. Tightening torque : (B) : 21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft) (C) : 37.3 ~ 41.2 N.m (3.8 ~ 4.2 kgf.m, 27.5 ~ 30.4 lb-ft)

4.	Grease the pivot portions of the hinges indicated.

5.	Check for water leaks.

Components and Components Location

Components 1. Front door inside handle cap2. Front door pull cap3. Front door trim4. Front door module5. Front door frame inner cover 6. Front door latch assembly7. Front door panel8. Front door ...

Front Door Trim Components and Components Location

Component Location 1. Front door trim ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Power Latch Assembly Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the trunk lid trim after opening the trunk. (Refer to Body - "Trunk Lid Trim") 3. Remove the power latch (A) after disconnecting the connector (B) and mounting bolts. 4. Remove the power cinching actuator (A) after d ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Description and Operation

Description The hydraulic system consists of oil, an oil filter, an oil pump, and a valve body (valves and solenoid valves). The oil pump is powered by the engine. ATF passes through the oil filter and gets distributed along the oil channels. The oil becomes highly pressurized as it exists in ...