Hyundai Genesis: Fuel Filler Door / Repair procedures

Replacement

• Put on gloves to prevent hand injuries.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • Take care not to scratch the body surface.

1.	Open the fuel filler door cap (A).

2.	Remove the fuel filler door pushpin (A) by turning it in a counterclockwise direction.

3.	After loosening the mounting screws, remove the fuel filler door (A). • When removing, pull out the packing part from inside not to damage the fuel filler door packing part

4.	Install in the reverse order of removal. • Make sure the fuel filler door locks/unlocks and opens/closes properly. • Replace any damaged clips.

Components and Components Location

Component Location 1. Fuel filler door ...

Front Door

...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Injector Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal     ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Stop Signal Electronic Module Specifications

Specifications CategoryDataOperation temperature range (°C)-40 ~ 85Preserving temperature range (°C)-40 ~ 105Operating voltage (V)5.8 ~ 16Rated current (A)15 ...