Hyundai Genesis: Crankcase Emission Control System / Positive Crankcase Ventilation (PCV) Valve Repair procedures

Hyundai Genesis (DH) 2013-2016 Service Manual / Emission Control System / Crankcase Emission Control System / Positive Crankcase Ventilation (PCV) Valve Repair procedures

Removal
1.
Disconnect the vapor hose (A).
2.
Remove the rubber pad (B), and then remove the PCV valve.

Inspection
1.
Insert a thin stick (A) into the PCV valve (B) of the threaded side to check that the plunger moves.

   
If the plunger does not move (PCV valve is clogged), clean or replace the valve.
Installation
1.
To install, reverse the removal procedure.

PCV Valve installation:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Positive Crankcase Ventilation (PCV) Valve Description and Operation
Operation Principle ...

Evaporative Emission Control System
...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Auto Defogging Actuator Description and Operation


Description The auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake ac ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Knock Sensor (KS) Repair procedures


Removal [Knock Sensor #1 (Bank 1)] 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the knock sensor connector (A). 3. Remove the installation bolt (A), and then remove the sensor from the cylinder block. [Knock Sensor #2 (Bank 2)] 1 ...

© 2013-2025 www.hgenesisdh.com