Hyundai Genesis: Body Side Molding / Front Wheel Guard Repair procedures

Replacement
   
Put on gloves to prevent hand injuries.
   
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Take care not to scratch the body surface.
1.
Remove the front tire.
2.
After loosening the mounting clips, nuts, bolts and screws, remove the front wheel guard (A).

3.
Install in the reverse order of removal.
   
Replace any damaged clips.
Roof Side Molding Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Rear Wheel Guard Repair procedures
Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around ...

Other information:

Hyundai Genesis (DH) 2013-2016 Owners Manual: Fuel filler door


Opening the fuel filler door The fuel filler door must be opened from inside the vehicle by pushing the fuel filler door opener button. 1. Turn the engine off. 2. Push the fuel filler door opener button. 3. Pull the fuel filler door (1) out to fully open. 4. To remove the fuel tank ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Transmission Oil Temperature Sensor Repair procedures


Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the resistance is within the specification. ...

© 2013-2025 www.hgenesisdh.com