Hyundai Genesis (DH): Lighting System / Door Mirror Lamp Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the mirror holder (A) from the outside mirror assembly.
|
| 3. |
Remove the door mirror housing (A) after loosening a screw.
|
| 4. |
Remove the puddle lamp (B) after disengaging the mounting clip.
|
| 5. |
Disconnect the puddle lamp connector (A).
|
| Installation |
| 1. |
Install the puddle lamp. |
| 2. |
Install the door mirror cover and housing. |
| 3. |
Install the door mirror. |
| 4. |
Connect the negative (-) battery terminal. |
Inspection 1. Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) 2. Check the fuse and relay. 3. Check the ballast power supply terminals (if the terminals are reversed, the low beam does not illuminate.
Removal 1. Disconnect the negative (-) battery terminal. 2. Separate the room lamp (B) from the roof trim after disengaging the mounting clip (A).
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Cluster Ionizer Repair procedures
Inspection 1. Press the MODE switch more than 4 times within 2 seconds while pressing the OFF switch. DisplayFail description00Normal51Cluster ion generator fault * For diagnostic procedure, refer to DTC guide. Replacement 1. Disconnect the negative (-) battery terminal.
Hyundai Genesis (DH) 2013-2016 Service Manual: Heater & A/C Control Unit Repair procedures
Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup temperature display panel every 0.5 second and will show two figures.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Electric Parking Brake (EPB) Repair procedures
- Emission Control System
- Description and Operation
- New on site
- Most important about car
