Hyundai Genesis (DH): Air Conditioning System / CO2 Sensor Description and Operation
Hyundai Genesis (DH) 2013-2016 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / CO2 Sensor Description and Operation
| Description |
This system maintains the density of carbon dioxide
constantly in vehicle interior by measuring the amount of carbon dioxide
to increase the comfortableness and the fuel consumption rate when air
conditioning system is operating.
| 1. CO2 sensor signal 2. Ground | 3. IG2(12V) |
Inspection 1. Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature.
Interface Diagram
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Indicator Repair procedures
Removal Blind Spot Detection Warning Indicator 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror (A). Installation Blind Spot Detection Warning Indicator 1. Install the outside mirror. 2. Connect the negative (-) battery terminal.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- Body (Interior and Exterior)
- General Information
- Steering System
- New on site
- Most important about car
Copyright В© 2025 www.hgenesisdh.com - 0.02