Hyundai Genesis: Maintenance / Brake fluid

Checking the brake fluid level

Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir.

Before removing the reservoir cap and adding brake fluid, clean the area around the reservoir cap thoroughly to prevent brake fluid contamination.

If the level is low, add the specified brake fluid to the MAX level. The level will fall with accumulated mileage. This is a normal condition associated with the wear of the brake linings. If the fluid level is excessively low, have the brake system checked by an authorized HYUNDAI dealer.

WARNING

If the brake system requires frequent additions of fluid this could indicate a leak in the brake system. Have the vehicle inspected by an authorized HYUNDAI dealer.

WARNING

Do not allow brake fluid to come in contact with your eyes. If brake fluid comes in contact with your eyes, flush your eyes with clean water for at least 15 minutes and get immediate medical attention.

CAUTION

• Do not allow brake fluid to contact the vehicle’s body paint, as paint damage will result.
• Brake fluid, which has been exposed to open air for an extended time should NEVER be used as its quality cannot be guaranteed. It should be disposed of properly.
• Do not use the wrong kind of brake fluid. A few drops of mineral based oil, such as engine oil, in your brake system can damage brake system parts.

✽ NOTICE

Use only the specified brake fluid (refer to “Recommended Lubricants and Capacities” in chapter 8).

Changing engine coolant

Have coolant changed by an authorized HYUNDAI dealer according to the Maintenance Schedule at the beginning of this chapter. WARNING Do not use engine coolant or antifreeze in the washer ...

Washer fluid

Checking the washer fluid level Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use wash ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Schematic Diagrams

Schematic Diagram • MAFS : Mass Air Flow Sensor • MAPS : Manifold Absolute Pressure Sensor • PCSV : Purge Control Solenoid Valve • FTPS : Fuel Tank Pressure Sensor • CCV : Canister Close Valve ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Height Adjust Repair procedures

Replacement 1. Remove the front seat belt upper anchor. (Refer to Front Seat Belt - "Front Seat Belt Retractor") 2. After loosening the mounting bolts, remove the height adjustor (A). Tightening torque : 39.2 ~ 53.9 N.m (4.0 ~ 5.5kgf.m, 28.9 ~ 39.8 lb-ft) 3. Install in the revers ...