Hyundai Genesis: Roof Trim / Assist Handle Repair procedures

Replacement

• Put on gloves to protect your hands.

• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. • Take care not to bend or scratch the trim and panels.

1.	After lifting up the assist handle caps (A) and loosening the mounting screws, remove the assist handle (B).

2.	Install in the reverse order of removal.

Assist Handle Components and Components Location

Component Location 1. Assist handle ...

Roof Trim Assembly Components and Components Location

Component Location 1. Roof Trim Assembly ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Barometric Pressure Sensor (BPS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the BPS at idle and with the ignition ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disco ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Fuel Pressure Sensor (FPS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Check the output voltage of fuel pressure sensor (FPS). Specification: Refer to “Specification” Removal 1. Turn ignition switch OFF and disconnect the negative (-)battery cable. 2. Fold the rear seat cushi ...