Hyundai Genesis (DH): Automatic Transmission Control System / 6 Speed Clutch Control Solenoid Valve Specifications
| Specifications |
| Control Pressure kpa (kgf/cm?, psi) | 0~1569.06 (0~16,0~227.57) |
| Current value(mA) | 0~1100 |
| Internal resistance(?) | 5.0~5.6 |
Description 6 Clutch control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 6 Clutch.
Circuit Diagram
Other information:
Hyundai Genesis (DH) 2013-2016 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the blind spot detection (BSD) switch (A) after disengaging the mounting clip. Installation 1. Install the crash pad side switch assembly after connecting the connector.
Hyundai Genesis (DH) 2013-2016 Service Manual: Heater Unit Components and Components Location
Component Location Components (1) 1. Shower duct (Left)2. Mode actuator (LH)3. Temperature control actuator (LH)4. Temperature door lever (Left)5. Mode actuator (A)6. Console temperature actuator (A)7. Console mode actuator ON/OFF8. Heater case (Left)9.
Categories
- Manuals Home
- Hyundai Genesis Owners Manual
- Hyundai Genesis Service Manual
- 4 Wheel Drive (AWD) System
- Components and Components Location
- Starter Repair procedures
- New on site
- Most important about car
