Hyundai Genesis: Automatic Transmission Control System / 35R Clutch Control Solenoid Valve(35R/C_VFS) Description and Operation

Hyundai Genesis (DH) 2013-2016 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / 35R Clutch Control Solenoid Valve(35R/C_VFS) Description and Operation

Description

35R Clutch control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 35R Clutch.

4&OD Clutch Control Solenoid Valve Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between solenoid valve terminals. 4. Check that the resistance is within the spec ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Specifications

Specifications Direct control VFS[35R/C] ? Control Type : Normal high type Control Pressure kpa (kgf/cm?, psi)0~2108.42 (0~21.5~305.80)Current value(mA)0~1100 Internal resistan ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Fuel Pump Control Module (FPCM) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. If there is DTC on the GDS, replace the FPCM. 3. Check the output voltage of fuel pressure sensor (FPS). Specification: 5V 4. Check the output voltage of fuel pressure sensor (FPS) at idle. Specification: 1.4 ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Power Trunk Module Drive Unit Repair procedures

Removal 1) Put on gloves before removing/installing the drive unit. 2) Do not install or carry a push rod, controller and wire harnesses by holding it with bare hands . 3) Be careful when removing the push rod, the trunk may close. 1. Disconnect the negative ( ...