Hyundai Genesis: Automatic Transmission Control System / 27 Brake Control Solenoid Valve Schematic Diagrams

Circuit Diagram

27 Brake Control Solenoid Valve Specifications

Specifications Direct control VFS[27/B] ? Control type : Normal low type Control Pressure kpa (kgf/cm?, psi)0~1569.06 (0~16,0~227.57)Current value(mA)0~1100 Internal resistance ...

27 Brake Control Solenoid Valve Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between solenoid valve terminals. 4. Check that the resistance is within the spec ...

Other information:

Hyundai Genesis (DH) 2013-2016 Service Manual: Rear Bumper Cover Repair procedures

Replacement     • Put on gloves to prevent hand injuries.     • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. • When removing the interior trim pieces, use a ...

Hyundai Genesis (DH) 2013-2016 Service Manual: Engine Control Module (ECM) Repair procedures

Removal     For the vehicle equipped with the immobilizer, the procedures shown below must be performed after replacing the ECM. [In the case of installing used ECM] 1) Perform "ECM Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group) 2) After finishing ...